We are very grateful, thank you very much for purchasing our Chapter 5.1 Chrono Magma!


Let us give you some tips and explain how to adjust your timepiece to your wrist...

MOVEMENT

Automatic ETA/VALJOUX 7750 

                                               

CASE

ø44.0 mm, 16.5mm thickness (excl. glass), stainless steel 316L silver with red mineral glass case back 


BEZEL

Ceramic bezel with tachymeter 


POWER RESERVE

48 hours


FREQUENCY

3hz (21'600 Alt/H)


DIAL

12H+6H Counters polished in black  / 9H Counter transparent disk 


WATER RESISTANCE

10 ATM


GLASS

Sapphire box crystal glass with double anti reflective coating and printed logo 


HANDS

Skeleton hands with SuperLuminova® 


STRAP

Medium size, black Croco pattern genuine leather, black stitches with deploying buckle 18,0 mm, NFC technology included 


How to handle your Chrono Magma :




1 Crown 

If necessary, pull out the crown by turning counter‐ clockwise (towards yourself) 

Position 1 allows manual winding of the timepiece by turning the crown clockwise (away from yourself) 

DO NOT ADJUST THE DATE BETWEEN 9PM AND 3 AM. IT MAY DAMAGE THE DATE MECHANISM. 

Position 3: adjusts the time  


2 Chronograph Start/Stop 


Press this button once to start the chronograph seconds hand. 

Press this button again to stop the chronograph seconds hand. 


3 Chronograph Reset 


After stopping the chronograph, press this button to reset the chronograph registers back to zero. This button will not work if the chronograph is still active. 


4 Chronograph seconds hand 


When the chronograph is activated the central chronograph hand will rotate once around the dial every 60 seconds. 



5 Chronograph 30‐minute counter 


After each 60‐second rotation of the chronograph seconds hand, this counter will register an additional minute up to 30 minutes. 



6 Chronograph 12‐hour counter 


This counter registers each half hour of chronograph elapsed time up to 12 hours.  



7 Chronograph 60 seconds hand 



8 Date Window 



Step 1: Winding the automatic mechanical movement 


An automatic mechanical watch recharges itself through the movement of its oscillating rotor located at the back of the watch (kinetic energy). However, when your watch is completely stopped, it is recommended to manually wind it around 15 times to provide it with an initial boost. 


Caution: Push the crown back to its original position to maintain the watch's water resistance. 



Step 2: Setting the time 


To set the time: pull the crown and turn the hands in order to go forward in time.  


Caution: do not turn the hands in the opposite direction and do not forget to push the crown back in when the operation is finished. 



Step 3: Adjusting the strap 


To fix the strap, put the 6 hour strap through the open space on the 12 hour strap, at the entrance there are two small pins that come out. Adjust the bracelet to your size. Once you are comfortable with the size. Press hard enough to get the two pins into the holes of the lower bracelet. Be careful, the holes are small, tightened in a voluntary way. You can use a flat tool to help you push the bracelet into the holes. Press a little on the bracelet around the two pins, which will allow you to finalize the fixing.